A novel architecture of electro-hydrostatic actuator with digital distribution

To address the flow imbalance rapidly of the asymmetric Electro-Hydrostatic Actuator (EHA), this paper presents a novel architecture of asymmetric EHA with the Digital Distribution (EHA-DD). It also improves the flow nonlinearity and control accuracy of the pump, especially in the low-speed condition. The digital distribution with two High-Speed on–off Valves (HSVs) not only balances flow instead of the check valves, but also replaces the pump at the low-speed to control output flow by adjusting the PWM signal. The pump and HSVs are the crucial components to control flow output. Firstly, the flow calculation models of the pump and the duty ratio inversed model of the HSV are obtained through experimental tests and the identification method. To get the control input signal for the required flow, the pump speed and PWM duty ratio for the HSVs are inversed to compensate for flow output. Further, a multimode digital flow distribution control method based on pump speed, mainly including the pump-controlled mode for large flow demand and valve-controlled mode for little flow demand, is proposed to control the accurate flow output actively. The step extension experiments based on the flow calculation models are conducted on the EHA-DD prototype under elastic, opposite varying load. The results demonstrate that the EHA-DD realizes little position error by accurate flow control, and it is also beneficial to improve the service life of the pump.     

碳纳米管阵列推力器放电特性的数值模拟研究

基于直接蒙特卡洛(DSMC)算法、浸入式有限元算法(IFE)、粒子云及蒙特卡洛碰撞(PIC-MCC)算法以及Ammosov-Delone-Krainov(ADK)隧穿电离模型建立了碳纳米管阵列推力器工质气体和CNT场电离过程的三维仿真模型。利用文献中的实验数据对本文仿真模型的有效性进行了验证,结果表明本文仿真模型与实验结果基本一致。针对碳纳米管阵列推力器的放电特性进行了研究,并重点分析了离子与原子碰撞过程对碳纳米管阵列推力器放电特性的影响。结果表明CNT可以极大地增强局部电场,稳态时场增强因子约为1308;与原子的碰撞使得离子在CNT附近更加集中,降低了局部电场,进而降低了其场增强能力。     

不同直径圆球诱导燃烧的振荡机制与频率特性

为了分析不同直径圆球诱导振荡燃烧的规律，并揭示圆球大小在振荡燃烧现象中所发挥的深层次作用，本文采用二维轴对称Euler方程和基元反应模型，对不同直径的圆球在H2/air预混气体中诱导振荡燃烧的现象开展数值模拟研究。研究发现，振荡频率并不是简单地随直径增大而逐渐从高频向低频连续过渡，而是存在两次突变，形成了超高频、高频以及低频三种振荡燃烧模态。在两种模态间过渡时，振荡达到稳定状态前，会存在一段双频耦合的振荡阶段。三种不同振荡燃烧模态的产生是受到了不同振荡机制的作用，而两种模态间过渡时的双频耦合现象则是两种机制相互竞争的结果。     

Alfvén gravity waves in viscous solar plasma: Effect of the background flow

We study the Propagation and damping properties of Alfvén gravity waves in the presence of the vertical magnetic field in the viscous solar plasma under influence of the background flow by deriving a fourth order dispersion relation in terms of the Doppler shifted frequency. We derive the dispersion relation under WKB and Boussinesq approximation. We study the damping of Alfvén gravity waves for the wave frequencies less than and greater than the Brunt-Väisälä frequency. We find that the Brunt-Väisälä frequency divides the frequency ranges where the weakly or strongly damped oscillations occur. The background flow exhibits a strong effect on weakly damped oscillations and a weak effect on the strongly damped oscillations. We also notice that the damping of both the strong and weakly damped oscillations depend on the Brunt-Väisälä frequency and wave number. The effect of the background flow is also being governed by the Brunt-Väisälä frequency and wave number. We also study the properties of gravity wave mode after filtering the Alfvén wave mode by minimizing the magnetic field and noticed that the background flow shows a very strong effect on the gravity wave mode.     

偏心撞击对撞击式喷嘴雾化特性的影响

为研究偏心撞击对撞击式喷嘴雾化特性的影响,建立了求解自燃推进剂冷态射流撞击雾化过程的数值模拟方案,计算了不同偏心度条件下的射流撞击雾化过程。采用树形自适应加密算法直接求解不可压Navier-Stokes方程组,由分段线性的流体体积(VOF)方法对流体界面进行捕捉。结果表明偏心撞击会导致雾场发生偏转,当无量纲偏心度E为1/8时,雾场偏转角度约为9.2°,应控制加工偏差小于该值。随着偏心度的增大,液膜的偏转角度增大,理论推导得到的液膜偏转角度要小于数值计算得到的液膜偏转角度。正心撞击时燃料与氧化剂流强峰值接近,雾场的流强分布呈单峰分布。当发生偏心撞击时,由于燃料与氧化剂部分射流未参与撞击导致流强峰值出现交错,雾场的流强分布呈双峰分布,混合比的空间分布发生较大改变。正心撞击时撞击点下游液滴的速度分布近似呈轴对称分布,而偏心撞击之后的速度分布则呈中心对称分布。偏心撞击导致的射流动量损失使得雾化性能变差,当无量纲偏心度E为1/8时,一甲基肼(MMH)的Sauter平均直径增大约4.8%,四氧化二氮(NTO)的Sauter平均直径增大约5.8%。      

跨介质航行器波浪环境入水流场演变和运动特性研究

跨介质航行器是一种既可以在空中飞行又可以在水下潜航的新概念航行器,基于仿生学原理,提出一种通过改变外形实现水空介质跨越的航行器模型,通过入水试验装置和计算流体动力学方法,对航行器带攻角从空气到水的介质跨越过程进行了试验和数值仿真研究,得到了跨介质入水过程航行器的运动姿态和入水空泡形态,并通过数值仿真得到了航行器的升力、阻力、速度和加速度演化规律。同时基于数值模拟方法对有波浪情况和静水情况下航行器入水过程空泡演变以及运动特性进行对比。结果表明:提出的航行器构型在水中具有较好的姿态调整能力,波浪的有无和波高的不同都会对航行体入水运动特性造成影响。     

基于新型丝状电极等离子体激励器的前体涡控制

本文首次将新型丝状暴露电极DBD等离子激励器应用于大迎角下细长体非对称涡控制。丝状暴露电极的材料的选择对DBD推力以及推力效率至关重要,通过地面精细推力测量对丝状暴露电极等离子体激励器进行了优化,结果表明,本文研究材料中采用钨丝作为暴露电极,其推力效率最优;且随着电极直径从d=0.3 mm减小到d=0.08 mm,DBD推力效率显著提升。基于优化后的DBD激励器,将其应用于前体非对称涡控制:未施加等离子体控制时,压力测量以及PIV结果均表明细长体背风区流场为明显的非对称涡结构;在等离子体激励下,该非对称涡结构可变为对称甚至反向非对称,且非稳态激励控制能力明显优于稳态激励。研究发现,大迎角下细长体非对称涡控制与背风区原始涡系结构有关,其中包含对称涡系和非对称涡系。本文研究为大迎角下细长体非对称涡控制提供了一种新思路,同时也为丝状暴露电极DBD等离子体激励器的应用提供参考。     

Initiation characteristics of oblique detonation waves from a finite wedge under argon dilution

In this paper, the flow field characteristics of Oblique Detonation Waves (ODWs) induced by a finite wedge under argon dilution are studied by solving the Euler equations with a detailed chemical model of hydrogen and air. First, the effects of the expansion waves, argon concentration, geometric parameters, and Mach number on the ODW are discussed. The results show that the changes of these parameters may make the oblique detonation not be initiated. Then, the ODW initiation criterion of the finite wedge is summarized, as the characteristic length of the induction zone L_C and the characteristic length of the oblique wedge L_W meet the condition L_C/L_W < 1, the initiation of the ODW occurs; otherwise, it does not occur. What’s more, the Constant Volume Combustion (CVC) theory is applied to study the characteristic length of induction zone. It is found that CVC theory is more suitable for the “smooth transition” type of ODW flow field, the theoretical and numerical characteristic length in induction regions are in good agreement. This work is of great significance for the design of oblique detonation engines for hypersonic vehicles.     

直升机新型旋翼翼型气动特性与布局分析

利用结构网格计算流体力学(Computational fluid dynamics ,CFD)的翼型气动特性分析方法开展旋翼翼型气动特性计算。通过RAE282，NACA0012，OA212，OA207等翼型压力分布、升力和阻力等特性计算结果与试验结果的对比分析，验证了计算方法的准确性，并进一步完成了HF系列旋翼翼型的气动特性计算。基于翼型的气动特性，采用时间步进自由尾迹的旋翼气动性能分析方法开展旋翼桨叶翼型的气动布局优化设计，对悬停和前飞条件下的旋翼开展计算分析，得到两种条件下的旋翼气动特性。而后通过本文建立的优化方法开展旋翼翼型布局优化设计。     

基于变马赫数的五孔探针三维插值方法

探讨了五孔探针气动数据的插值方法,为提高插值精度,开发了基于传统线性插值法的三维线性插值法。该方法把同一探针在不同马赫数下的校准图形成三维数据库,将实验数据通过三维图进行插值。并使用改进前后的两种插值方法分别对校准风洞测得的数据进行整理,对比结果证明:在实验工况连续变化的情况下,三维线性插值法在插值精度上要优于传统线性插值法。特别是在来流马赫数变化较大时,该方法可以改善单一校准文件处理造成的数据精度问题,可用于自动化流场采集系统,为流场高速高精度采集奠定基础。